If you plan on putting a finish over the oil be sure it has had plenty of time to dry. 2. One aspect of unfinished wood is that the natural material will readily soak up water and other liquids, which leads to … 3 Apply More Than One Danish Oil Coat. The pre-stain is going to end up making your Danish oil finish look lighter than advertised. If it’s a top, like a dresser top or table top, I sand to 320. Watco makes a "Rejuvenating Oil" that seems to be just mineral spirits and a very small amount of resin. I've used Watco Danish oil on quite a few projects and have never had any issues with applying it at low temps. Drying times will vary at different temps and humidity. After drying overnight, do the same thing again. If the finish is still tacky, I have to believe that there is still excess Danish Oil on the surface of the wood. It's a linseed oil with a small amount of resin or varnish added. The instructions are to apply, let set and then wipe dry. How to Apply Danish Oil on Wooden Floors. Steve Nuel thanks for your advice. And it goes on thin, so apply a minimum of three coats. Oil is very easy to apply as it is not sensitive to dust, handprints or over‐application. At best, it should leave a somewhat soft glow. Tried and true oil, is … Danish oil coating is resistant to water and liquids. Watco Danish Oil vs. Polyurethane for Wood Finishing. Use 600-grit wet-dry sandpaper and the Danish oil as a lubricant, photo below. Re: Low tempurature for Watco Danish oil Yes. As its particles contain the characters of polymerization, it provides a solid texture upon drying. When you use Watco, after you apply it you should wipe the surface down well to remove any excess. Danish oil over oil-based stain. You don't have to worry about brush marks, but you'll get an even smoother finish by lightly "wet" sanding between the second and third coats. Go back after 15 minutes or so and check the surface for any oil that may have come back up and wipe it dry again. Watco Danish oil from a local hardware store works fine, it’s a thinner oil so we usually put on at least one more coat to help build the finish on the wood. Danish oil dries slowly, so wait overnight before recoating. Danish oil is known as a hard-drying oil because when its particles react with oxygen in the atmosphere, they are polymerized into a solid layer. It is intended to be a penetrating oil. I also emailed the "RustOleum/Watco people and received this reply back: " Hi Joe, The Danish Oil is a penetrating oil and is designed to harden in the wood, not on the wood. Enhances the Sheen I know I'm late on this but Watco Danish Oil is not intended to leave a glossy finish. So make sure you have enough Danish oil to apply at least two coats. I apply the Oil wet, not a flood, but wet, with a t-shirt piece (everything I am going to apply will be with a cotton T-shirt) I let it sit for 15 mins and wipe dry! I apply Watco Danish Oil Natural after sanding to 220. The information in this blog post applies to all oil finishes. Oil penetrates into the wood, fills its open pours and protects from within. It also provides a very rich WATCO DANISH OIL FINISH Overview. Because mineral spirits is a solvent for wax, when you apply it, it dissolves the wax and when you wipe down the furniture, all the old wax and gunk comes right off. Then I do it again, right away. This is because wood conditioner is so good at its job at preventing Danish oil from being quickly absorbed. What you will have to watch is drying time. Watco Danish oil is a brand of wood finish product also referred to as an oil/varnish blend, because it contains both penetrating oil and varnish. Be sure and hang or lay out any oily rags to dry before you discard them.